Pixel limit with Ar...
 
Notifications
Clear all

Pixel limit with Arduino controller?

4 Posts
3 Users
0 Reactions
1,844 Views
Posts: 15
Topic starter
(@rbf351)
Eminent Member
Joined: 11 years ago
[#41280]

Currently i am running 800 WS2811 Pixels in a matrix via an Arduino Mega

I can use Vixen with no issues, but every once in a while all of the pixels will flicker.

Is there a better solution to controlling these as i am using this as a window display, and am looking to possible move this over to an ethernet connection instead of a 25 foot usb cable


3 Replies
Posts: 274
(@kartingted)
Reputable Member
Joined: 13 years ago

There are small pixel controllers around
Sandevices E6804
Alphapix 4
Pixilite 4
Espixel and espixelstick
These all run of E1.31 which is ran via a Ethernet cable
The last two that are similar and ran over wireless but you will need two to run that many pixels
There is also a raspberry pi running falcon pi player
Your very long usb cable could be causing you some trouble


Reply
Posts: 15
Topic starter
(@rbf351)
Eminent Member
Joined: 11 years ago

I see there is also a way to use Renard via Arduino. Does anyone happen to have the sketch for an Arduino? From there i can get a Network Shield.


Reply
Posts: 31
(@bobmcnobby)
Eminent Member
Joined: 12 years ago
rbf351 wrote:Currently i am running 800 WS2811 Pixels in a matrix via an Arduino Mega

I can use Vixen with no issues, but every once in a while all of the pixels will flicker.

Is there a better solution to controlling these as i am using this as a window display, and am looking to possible move this over to an ethernet connection instead of a 25 foot usb cable

800 pixels = 1/800000 * 8bits * 3bytes * 800 pixels = 24ms
if you are running at 25Hz, that is 24ms for the pixels (uninterrupted flow) and 16ms for receiving of the 2400bytes over serial

perhaps you dont have enough processor time left ?

---

What baud rate is the serial stream being received at ?
It would probably need to be 1MHz, but I think I have read it is about 57,800 or 78,600 or something similar

I developed a simple DMX->WS2812 device (250kbps to 800kbps) and to get over any flickering or missing frames I had to interleave the RX and TX together in the same piece of assembler

Perhaps the same would be required here


Reply
Share: