Connecting Pixel St...
 
Notifications
Clear all

Connecting Pixel Strings

13 Posts
5 Users
0 Reactions
4,105 Views
cwalkeree
Posts: 173
Topic starter
(@cwalkeree)
Estimable Member
Joined: 15 years ago
[#41260]

Can I connect 10 pixel strings together to make a string of 500 and use that one string on a single output when using an e682 or does it not work that way and i'll have to make 4 strings of 125 pixels to separate those between the 4 outputs of the cluster?


12 Replies
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

You can but you will need to use power injection. If you use 125 for each output on the 682 you wouldn't need injection. BTW. Are you using 5 or 12 volt pixels? Using 12 volts you should be able to use 125 pixels for each output on the 682. Not likely you'll be able to drive 125 pixels from one output using 5 volts.

Sent from my Nexus 7 using Tapatalk


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

You may see data refresh degradation @ 500 pixels on a single output.
I would like to see results of actual testing .
If you do give this a go please report your results .


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

I run 300 pixels at 12 volts and 480 pixels at 5 volts each with a single E6804 output (separate controllers) and haven't had any issues. I do use injection.

Sent from my Nexus 7 using Tapatalk


Reply
cwalkeree
Posts: 173
Topic starter
(@cwalkeree)
Estimable Member
Joined: 15 years ago

I am using 12V. I have a 504 pixel window grid that I'm using in an April show! I'm trying to figure this out.. Will do trial and error but was just gonna try and borrow some wisdom. I am almost finished connecting these wires and I will report my results.


Reply
Page 1 / 3
Share: