Help With 2nd E682
 
Notifications
Clear all

Help With 2nd E682

21 Posts
6 Users
0 Reactions
3,626 Views
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

The image isn't the best, the flash washes things out. I see a couple of solder points that don't look good. I would go along and re-flow each of the connections - especially on the 5V items (top of board) and also check for bridging - it's hard to tell, but I think I can see at least one bridge between two solder connections.


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

When I plug in the ethernet I get a solid orange light and the green light flashes, and it is plugged into a switch, If I plug my other E682 into the same ethernet that one allows me to access the webpage just not the new one E682


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago

I second gassy's comments about the solder joints. Redo them and also make sure you don't have any bridged solder joints as well.


Reply
Posts: 54
(@microproce)
Trusted Member
Joined: 16 years ago

What I can advise you first,HR from the board or use a soft for scan your network. If it's not good, exchange with your second card the ethernet module.
Seen your video, the card starts well. Only communication is impacted by the problem.


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

I will try to do a reflow and see if that works
I am not sure how to reload the firmware I have a pickit3 programmer if that would work


Reply
Page 3 / 5
Share: