Ok so this is what I am getting when I try to put numbers in the matrix part of the sign only
that is where I am having problems, I am not sure how to do that, sorry This is my first year setting all of this up and I can not figure it out at al...
Ok if I take the non working strand and move that to a working port the strand works fine, If I take the working stand and move it to the non working ...
This is my first year so I am not sure what you are asking about
Ok this is more then likely not make any sense and I am super confused now. If I take any working strand from me tree and plug into either one of the...
I get the something even running a test inside of the controller UI it will not light those 2 strands Here is a pic of the controller
No as I just set up everything and only put in a bar on one of my models and even that is almost like a strobe I am not sure what FPP is sorry
It is set to 192.168.1.206
Ok I tried to reflow and I removed the bridge connections but no luck. I have also tried to connect it directly to a pc using override 4 but still no ...
I will try to do a reflow and see if that works I am not sure how to reload the firmware I have a pickit3 programmer if that would work
When I plug in the ethernet I get a solid orange light and the green light flashes, and it is plugged into a switch, If I plug my other E682 into the ...
I think the only bad soldering points are on a couple of the 5a fuse holders My Soldering skills are not the greatest But let me know what you thin...
