Hey guys,
On to my 2nd year of this awesome hobby and I am expanding the show (who would have guessed). I have a single E682 controller and ran about 1800 pixels last year on unicast. I am adding about 1500 pixels this year and cannot seem to find if the max on the E682 is still 2040 or if that has changed. Can anyone shed some light? If still at 2040 I will be expanding and looking to add a 2nd E682. Is it difficult to add on a 2nd E682? Would I be better served swapping to something like a Kulp 16A-B?
It is still 2040 I believe. You can definitely add multiple E682s (or 6804s). I had 6 at one time! Just assign a different IP address.
joeyw1986 wrote:Hey guys,On to my 2nd year of this awesome hobby and I am expanding the show (who would have guessed). I have a single E682 controller and ran about 1800 pixels last year on unicast. I am adding about 1500 pixels this year and cannot seem to find if the max on the E682 is still 2040 or if that has changed. Can anyone shed some light? If still at 2040 I will be expanding and looking to add a 2nd E682. Is it difficult to add on a 2nd E682? Would I be better served swapping to something like a Kulp 16A-B?
The max output is in the product description on the Sandevice website. If I recall it’s also in the assembly instructions. Page 3 of the operating manual:
Specifications:
Data Input:
E1.31, streaming DMX over Ethernet, multicast mode, up to 7 universes, or a total of 3570 DMX channels. E1.31, streaming DMX over Ethernet (SACN), unicast mode, up to 12 universes or 6,120 channels. Art-Net, unicast mode, up to 12 universes or 6,120 channels.
Output:
16 connectors for pixel strings, pixel strips, or DMX/Renard outputs.
6,120 channels equals 2,040 pixels.
Sent from my iPad using Tapatalk
It is not difficult to add another E682. I have several.
ezellner wrote:It is not difficult to add another E682. I have several.
So Last year I ran my show from my Raspberry Pi running an ethernet to my E682. I am assuming I would just add a second ethernet from the router to go to the new E682. Is that correct? I will have to look but I might have just the one port on my router. If so, can I run that to a splitter and then go to each controller from there?
