techs21 wrote:It is set to 192.168.1.206
Did you do the override codes listed in the operations manual to get that IP set, or are you relying on the default IP that the E682 was shipped with? If you haven't set it, perform the override 6 function listed in the operations manual. And, as angus40 asked, is your router IP default value 192.168.1.1? For a number of years, that's what mine was set to, but I changed routers just over a year ago and now my new default is 192.168.0.0 so on the new kit I just built a couple weeks ago I had to perform override function 5 to accommodate for that (since the E682 is shipped with a default of 192.168.1.206, I have to set it to 192.168.0.206 for my home network to see it).
I'm not trying to be nit-picky here, but I'm wondering why you chose to solder in your network connector directly to the board and not use the standoff sockets that should have come with the kit. The assembly instructions even say to plug in the ethernet socket into those standoffs, push them into the holes on the board, then you solder one point on each side, at which time you can remove the ethernet socket and finish soldering in the standoffs. Then you can plug and unplug your ethernet socket as needed. I say all this because I'm wondering if perhaps while soldering the socket to the board, you created too much heat and did some damage to the ethernet socket circuitry. I can't say for certain because I'm not an expert on these things, but I'm just giving a possibility here.
