ESPixelStick - E1.3...
 
Notifications
Clear all

ESPixelStick - E1.31 WiFi Pixel Controller

948 Posts
178 Users
0 Reactions
503.7 K Views
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago

Next run is in production and still on target to have more in stock mid to late February. Thanks!
-shelby


Reply
Posts: 16
(@smithzone)
Eminent Member
Joined: 9 years ago
sporadic wrote:Next run is in production and still on target to have more in stock mid to late February. Thanks!
-shelby

Nice, any issues with running about 15 at the same time (unicast and dedicated network with a pretty decent $150 wi-fi router).


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago
smithzone wrote:Nice, any issues with running about 15 at the same time (unicast and dedicated network with a pretty decent $150 wi-fi router).

sACN over WiFi should be done with Muticast, not unicast. Best results so far have been seen with a $50 dedicated access point. The Ubiquiti Nanostation loco M2. Seethis threadfor optimal settings.

I know that Dave has over 40 ESPixelSticks running, but only 2 universes. I have 26 running with about 20 universes total.


Reply
Posts: 19
(@cengiz)
Active Member
Joined: 11 years ago
sporadic wrote:The V2's have been doing very well and am planning to stick with the current design for now.

It would be great if you did v3 interface for v.2.


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago
cengiz wrote:It would be great if you did v3 interface for v.2.

Wouldn’t the better answer be to fix whatever is wrong with v3 that worked in v2?

Sent from my iPhone using Tapatalk


Reply
Posts: 86
(@onceler)
Estimable Member
Joined: 9 years ago

I'm having an weird issue, and I cant figure out whats going on. I connect and program the controller. The programming finishes, an IP is returned, I go to that in my browser. I can run a test everything is perfect. I reboot the controller, and the wifi card either never lights or if it does it blinks and never seems to connect again. If I go back and reprogram it connects fine until the next reboot where it doesnt connect again.

Is my esp bad? Or is there something to save the connection details?


Reply
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

Sounds like the same symptoms of the (now) well known issue with the PUYA branded flash chip.

If so, the answer is to replaced the flash chip or get another ESP-01 that doesn't have the PUYA branded one.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

I have since found another chip that doesn't work. It's labeled FM25Q08A. Here's a look at both the problem chips:

fm25q
puya

Reply
Posts: 86
(@onceler)
Estimable Member
Joined: 9 years ago

Is it reasonable to replace surface mount? Aside from ordering tons of esps how can be sure I'm getting something good?


Reply
TheLost
Posts: 189
(@thelost)
Estimable Member
Joined: 10 years ago
dirknerkle wrote:I have since found another chip that doesn't work. It's labeled FM25Q08A. Here's a look at both the problem chips:

It's getting harder and harder to find the ones that work.

I'll be happy to take bad ones off peoples hands 🙂


Reply
Page 89 / 95
Share: