ESPixelStick - cann...
 
Notifications
Clear all

ESPixelStick - cannot flash - does not connect

16 Posts
7 Users
0 Reactions
8,342 Views
Posts: 14
(@stonelovelights)
Active Member
Joined: 11 years ago

Here is my link up ... and I haven't seen any Red light on the ESP

hook up ESPixelStick V2

Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Power the bottom two terminal points to power the ESP
Need power on the ESP to program


Reply
beeiilll
Posts: 869
(@beeiilll)
Prominent Member
Joined: 19 years ago

You have to feed power and gnd to the stick to program. Can't do anything without power to the green connector!


Reply
Posts: 221
(@stenersonj)
Estimable Member
Joined: 17 years ago

I have a slightly different problem. Mine seems to program correctly. It says Programming Complete. but then I only get garbage characters in the serial window.
what am I doing wrong?


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago
stenersonj wrote:I have a slightly different problem. Mine seems to program correctly. It says Programming Complete. but then I only get garbage characters in the serial window.
what am I doing wrong?

Hi, when an ESP boots up its first serial report is at 78600 which shows as 'garbage characters in the serial window' (this happens every time and is normal), as soon as the software kicks in the serial is changed to 115200 and the characters are displayed in the serial window correctly.
The 'garbage' if read at the correct speed is something like this:


ets Jan  8 2013,rst cause:2, boot mode:(3,6)

load 0x4010f000, len 1384, room 16 
tail 8
chksum 0x2d
csum 0x2d
v09f0c112

The 'garbage' is only a problem if it continues for more more that a second or so.


Reply
Posts: 221
(@stenersonj)
Estimable Member
Joined: 17 years ago

Thanks for the help. I got it working. not sure what I was doing wrong.


Reply
Page 2 / 2
Share: