Pixel won't turn of...
 
Notifications
Clear all

Pixel won't turn off

3 Posts
2 Users
0 Reactions
1,556 Views
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
[#42631]

I'm running a E1.31 bridge. This is a pixel Pole setup. The pole uses output 1 for 125 pixels. The ball at the top uses output 2 for 4 pixels grouped. I already had the pole done when I decided to add the ball and using another output was easier than taking it apart to add 4 pixels at the end. Anyway, sequences work fine until I do a short burst of red and the ball doesn't turn off. Short burst meaning less than 1/2 second.Even at the end of the show the ball stays red. Doesn't seem to do it with any other color. They are 12 volt pixels. Any idea what could be causing this?

Sent from my SM-T710 using Tapatalk


2 Replies
lightsonmontague
Posts: 363
(@lightsonmontague)
Reputable Member
Joined: 11 years ago

Try lowering your voltage to under 12v.. ive had some pixels stay on with 12v i turned the power supply down with them stuck on and they shut off 11.5 seems to keep them happy


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
lightsonmontague wrote:Try lowering your voltage to under 12v.. ive had some pixels stay on with 12v i turned the power supply down with them stuck on and they shut off 11.5 seems to keep them happy

After posting I realized that's what I had to do. It was set at 11.9 volts. Turned down to 11.8 and the pixels turned off. Thank you.


Reply
Share: