E682 Question: How ...
 
Notifications
Clear all

E682 Question: How many "Sequence Errors" are normal?

10 Posts
8 Users
0 Reactions
3,707 Views
Posts: 654
Topic starter
(@szaske)
Noble Member
Joined: 14 years ago
[#22574]

I'll admit I'm probably a wacko when it comes to the amount of tweaking I do to my sequences (I mean I have a lot of effects in a song). I've been running for the last day with my lights up and I noticed in my E682 web interface I see 540,000 packets sent per cluster, and about 4,000 "Sequence Errors" per cluster...growing at about 10 packet errors per second per cluster. Is this normal? Is there a way I can troubleshoot these errors and remove them from my sequences? I'm using HLS as my playback software.

Steve


9 Replies
rokkett
Posts: 441
(@rokkett)
Reputable Member
Joined: 17 years ago

The sequence error count can be very harmless, depends on the software you are using to generate the E1.31 data stream. Some software "skips" sequence numbers in a universe, which ups this count, but you did not miss a packet. No data was really lost, so it is a total non-issue. But even if this does mean packets are getting lost in the network transport layer, you are at a < 1% missed packet rate, so I would not worry too much about it. Now your packet counts and the 10 errors per second observation do not seem to match up. I doubt you are sending 1350 good packets per second to each universe. 🙂 I wouldn't worry about dropped packets unless it was really affecting the display.


Reply
Posts: 1249
(@jstjohnz)
Noble Member
Joined: 17 years ago

What firmware version are you running on the E682?


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

If your using the J1sys addin to send to your E68x - if you send 10 packets you will get 9 errors or 1000 packets will get 999 errors. It's a know issue that has no effect on your show. There is a post started by me somewhere - I will look it later.


Reply
Posts: 654
Topic starter
(@szaske)
Noble Member
Joined: 14 years ago
jstjohnz wrote:What firmware version are you running on the E682?

I am using 2.049 firmware and HLS as my software. My show doesn't seem to be having problem, I just wanted to make sure I understand what is happening and if I'm doing everything correctly.


Reply
Page 1 / 2
Share: