Does the wreath have a wire frame? I had a wreath layout similar to what you are looking to do previously. I divided the wreath into equal sections ...
Great news, James! I know I just dropped to my knees in joy when my first RGB project came to life and worked properly. ANd it was only 510 pixel no...
Actually, you can just treat each controller as it's own standalone device. This would mean sending short universes to each devices for the last chan...
James, I was just shown how to do the unicast configuration in Vixen 3 - Right Click on the Destination option and enter the IP address of the contro...
The solution to the "we only want to move two cables" puzzler is: First e682:First three groups configured for 3 strands, 100 pixels. Fourth group co...
Ok, so I just tried to do this in Vixen 3, but I immediately ran into the unicast requirement issue for pixel density per controller issue. Is there ...
I think this is around here other places, but here is an spreadsheet formula to calculate the starting e131 starting address of a RGB pixel. It assum...
If you have 28, 100 pixels strands, you will need to configure the groupings on the e682 to allow for 28 ports to plug in each strand. I think you alr...
Thanks for the advice, I think I will try the DeoxIT and see what happens.... 🙂
Thanks, timon! Yes, I have been following your progress and would be interested in acquiring several of your devices when they become available. I w...
mykroft wrote:Just to let you know, this board started it design/creation last summer - way before any talk about a board like this started on the "ot...
