Notifications
Clear all

682 issue

9 Posts
8 Users
0 Reactions
3,125 Views
Posts: 366
(@technician)
Reputable Member
Joined: 12 years ago

Just an FYI on resistor packs, most can be installed either way as all values are the same. Indipendant resistors are on the same pins even when put in backwards. Packs with a common, eg 8 resistors to one common, the common is most often the center pin. again, they can go in either way. Only some odd ones are really sensitive about direction.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Looking at the E682 assembly manual, these rpacks are separate resistors so there is no orientation so just make sure you have the right values in the right place:

RNA, RNB, and RNC Resistor networks, RNA and RNC are 4.7 K ohms, RNB is 270 ohms. These 3 resistor networks will be identified by a number printed on the body. Although someresistor networks are polarized, these are not polarized and may be installed in either direction. RNA and RNC will havea part number containing “472”. RNB will have a part number containing “271”. Resistor networks may be yellow orblack in color.


Reply
Posts: 1249
(@jstjohnz)
Noble Member
Joined: 17 years ago

What you're seeing is normal, green LED appearance maywill vary somewhat with different firmware versions.


Reply
Posts: 357
Guest
(@jerry72)
Reputable Member
Joined: 13 years ago
dsmjuggalo wrote:I just got done building 3 more 682's and noticed a issue across all 3. I don't know if it's gonna cause problems yet as I have not put lights to them yet. Here's what's going on. When I power them up the green light is very dim. When I go in and change the test pattern the light has random flashes where it's bright but stays mostly dim. I built 3 682's and 4 6804's last year and had no issues with them. Any thoughts on what might cause this on all 3 of my new boards. Could the fact that I socketed all the chips be causing this issue?

Sent from my iPhone using Tapatalk

I just ordered the 682 today, i see the kit only comes with the IC sockets for the 20 in chips, but none of the others? All of them seem standard except the semiconductor. where did you get the socket for it?


Reply
Page 2 / 2
Share: