Notifications
Clear all

682 issue

9 Posts
8 Users
0 Reactions
3,124 Views
dsmjuggalo
Posts: 663
Topic starter
(@dsmjuggalo)
Prominent Member
Joined: 15 years ago
[#37568]

I just got done building 3 more 682's and noticed a issue across all 3. I don't know if it's gonna cause problems yet as I have not put lights to them yet. Here's what's going on. When I power them up the green light is very dim. When I go in and change the test pattern the light has random flashes where it's bright but stays mostly dim. I built 3 682's and 4 6804's last year and had no issues with them. Any thoughts on what might cause this on all 3 of my new boards. Could the fact that I socketed all the chips be causing this issue?

Sent from my iPhone using Tapatalk


8 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

First guess would be the resistor packs near the LEDs are wrong or in the wrong direction maybe. Definitely it has nothing to do with using sockets - my E681's use all sockets and have had no issues over the years.


Reply
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago

Send Jim an email and tell him what it's doing. He's good at responding and sending parts if needed.


Reply
Posts: 231
(@apollosmith)
Reputable Member
Joined: 12 years ago

That seems to be about how both of my new E682s work, and they work fine. The green LED is not full brightness when enabled (though not really "very dim"), and it blinks between off and medium brightness with the test pattern enabled, though I wouldn't call the blinking "random".


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

The newer boards use a different resistor pak than the old ones. Might be the issue.


Reply
Page 1 / 2
Share: