Super Strip Flood C...
 
Notifications
Clear all

Super Strip Flood Controller

240 Posts
30 Users
0 Reactions
91.6 K Views
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago
budude wrote:I was thinking once again about disconnecting pin 7 from the outputs so that SSRs can be safely plugged in with straight Cat5 cables. I might add a small set of pads so that you can put in a jumper if you need the additional source pin for something. I'm updating the entire silkscreen to make it easier to locate specific parts instead of something like "the tenth one over from the right"... oh - and it will be tinned this time too. :p

It would be nice to be able to control SSRs safely from the Ren48LSD. A more descriptive silkscreen will be good.


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago
Jrd wrote:It would be nice to be able to control SSRs safely from the Ren48LSD. A more descriptive silkscreen will be good.

I'm not seeing this... can you elaborate on why this is "desired goal"? No sarcasm intended on my part. I just don't understand why you would opt to use a more expensive controller (48LSD) to control SSRs. Versus using something in the "simpleREN" (or similar) series? (also gives you the zero cross capabilities which you would want with standard SSRs)


Reply
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago
LabRat wrote:I'm not seeing this... can you elaborate on why this is "desired goal"? No sarcasm intended on my part. I just don't understand why you would opt to use a more expensive controller (48LSD) to control SSRs. Versus using something in the "simpleREN" (or similar) series? (also gives you the zero cross capabilities which you would want with standard SSRs)

Say I only have 6 strips - that leaves 24 channels being unused (assuming you populated the entire board). You could then use standard ACSSR SSRs or higher powered DCSSRs for those channels obviating the need for an additional controller. Basically mix-n-match!


Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago
budude wrote:Say I only have 6 strips - that leaves 24 channels being unused (assuming you populated the entire board). You could then use standard ACSSR SSRs or higher powered DCSSRs for those channels obviating the need for an additional controller. Basically mix-n-match!

budude hit the nail on the head. Plus if someone was to accidentally connect an SSR to the 48LSD instead of a SuperStrip or similar then there would be no damage.


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

UHmm.. but if the 48LSD is being controlled by an incoming DC source.. you don't have zero cross.. so you wouldn't be able to dim the ACSSR's anyhow.
So (to me) this really doesn't seem a logical/viable solution.

(Again.. I suspect I'm not seeing the forest for the christmas-trees here)

The 48LSD is a powerful DC solution... none-better that I can think of. To me, however, it doesn't make too much sense to drive the ACSSR's with it.

Edit: Re-read Budude's quote.. and "High Power DCSSRs" - yes.. that makes sense to me. So the question becomes.. is the pinout changing in order to accomodate the DCSSR's? Or is this just a labelling exercise? I think the former makes a lot of sense, no so sure about the latter (label changing).


Reply
Page 37 / 48
Share: