Simple Renard Strob...
 
Notifications
Clear all

Simple Renard Strobe Burst

124 Posts
29 Users
0 Reactions
52.3 K Views
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

A few quick notes on the schematic
- 7805 regulators want ceramic caps on both input and output; data sheets recommend 330n on input and 10n-100n on output, right at the regulator pins. This reduces the chances that they go into oscillation
- Try to avoid 4-way junctions (like the one at the regulator's ground pin). It's easy to mis-read them when looking at a schematic.
- The module needs another 100n cap for IC2. 4017s are very sensitive to noise
- The LEDs are backwards, based on Q1.
- Since only one output of the 4017 is on at a time, you would be able to use one current-limiting resistor per 4017 (saving 18 resistors).

/mike


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
n1ist wrote:A few quick notes on the schematic
- 7805 regulators want ceramic caps on both input and output; data sheets recommend 330n on input and 10n-100n on output, right at the regulator pins. This reduces the chances that they go into oscillation
- Try to avoid 4-way junctions (like the one at the regulator's ground pin). It's easy to mis-read them when looking at a schematic.
- The module needs another 100n cap for IC2. 4017s are very sensitive to noise
- The LEDs are backwards, based on Q1.
- Since only one output of the 4017 is on at a time, you would be able to use one current-limiting resistor per 4017 (saving 18 resistors).

/mike

Hi Mike

Thanks for your recommendations, I will make some changes,, I thought about pulling all but one resistor but I was kinda worried about if the counters locked up for some reason and and the LED's were left full on that I might smoke the resistor,, but if I use two resistors one for each bank I should be OK. I will also add another cap to IC2

Thanks


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago

I have updated the schematic for the Strobe Burst Module in the first post per n1st recommendations.


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

For the current limiting resistors, you want one to feed all of the LEDs on one 4017, and one for the other. That's the way that ensures only one LED at a time per resistor is on.

LED1-LED20 are facing the wrong direction. Cathode should be tied to Q1 as it is a low-side switch.
/mike


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
n1ist wrote:For the current limiting resistors, you want one to feed all of the LEDs on one 4017, and one for the other. That's the way that ensures only one LED at a time per resistor is on.

LED1-LED20 are facing the wrong direction. Cathode should be tied to Q1 as it is a low-side switch.
/mike

Did not even notice that Cathode's were backwards,, my proto PCB has them in correctly,,,it's and old age thing;)

edit,,, schematic is updated in first post

Thanks


Reply
Page 2 / 25
Share: