Sawyer Star Redux (...
 
Notifications
Clear all

Sawyer Star Redux (???)

119 Posts
14 Users
0 Reactions
57.7 K Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
[#15120]

Today I mashed up the firmware from the Ren-C, Renard-DMX and the snowfall firmware that I was working on to come up with something that could be used to implement the Sawyer Star that was discussed in the fall of last year.

It uses a PIC16F627A, DMX receiver logic and the charlie-plex hardware logic. Below is an image of the PCB that I designed. It's a bit unrefined at the moment, as I might add an LED or two for status, and perhaps a few minor changes here or there. It is a single-sided board, which I might change to a two-sided board with a ground plane on the component side.

Now I'll have wait for another superflux LED coop in order to test it.

sawyer star

118 Replies
erm213
Posts: 479
(@erm213)
Honorable Member
Joined: 16 years ago

Looks neat. How many LEDs would it support in the star? Is each LED a channel?

Thanks,

Erik


Reply
erm213
Posts: 479
(@erm213)
Honorable Member
Joined: 16 years ago

Dupe...


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago

The original Sawyer Star had 60 individually controlled LEDs. The hardware/firmware that I've designed supports only 56 LEDs, so I figured that the middle 5 LEDs could be replaced with one central LED, or omitted altogether (probably the best choice).


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago

Incidently, a sawyer star is not the only possible application of the design. As designed it is a fairly general 56-channel DMX-interfaced charlie-plex/chipi-plex LED controller.

It could be used, for example, as a snowfall controller with DMX trigger, or as a linear-light-array controller with full computer control. It is a bit of over-kill for the first case, and quite similar in the second case to what djulien did with his garage-door array setup.

When I was designing it I also had in mind using it to drive up to eight 7-segment digits, perhaps for use as a countdown clock. I had in mind dedicating one pin of the PIC for a zero-crossing signal to keep track of time with the accuracy of the AC power line, and using another two pins for connecting a 32.768Khz watch crystal to help keep the time accurate when AC power goes down. The difficulty which made me abandon this aspect of the project was that most people would want to drive multiple LEDs in parallel, which is difficult to do with the charlie-/chipi-plexing approach.


Reply
Page 1 / 24
Share: