Activity
 
Notifications
Clear all
n1ist
@n1ist
Noble Member
Joined: Jan 5, 2008
Topics: 49 / Replies: 992
Reply
RE: How to space lights along an extension cord

I usually put a stake in the ground, ziptie the outlet and prop plug to the top of the stake, and shove a 20oz soda bottle over it. A little trimming...

3 years ago
Reply
RE: Microchip lead times

I designed a board with a $2 motor driver chip. I just had to approve buying 6000 of them at $13, but at least we could get those... We are now rede...

5 years ago
Forum
Reply
RE: Super-cheap DC-SSR

I would grow the traces between the power input connector and the ground on the chip, and to the output connectors. They are quite thin now. You can...

6 years ago
Forum
Reply
RE: Using bullet connectors

The connectors are uninsulated so the voltage rating is just as good as whatever you insulate them with and how well the insulation covers the ends to...

6 years ago
Reply
RE: Using bullet connectors

Make sure that there's no way to contact the sockets if they get unplugged, and of course use the male bullets on loads and the female sockets for sou...

6 years ago
Reply
RE: Some Kicad help?

Send them to me; I'll give it a try. /mike n1ist@arrl.net

6 years ago
Reply
RE: Trying to save a train

1. JP1 is power in (from 110-120 A/C) mains plug. 2. Full-wave bridge provides (unfiltered) DC (about 110 V) for lights. For a full-wave bridge, the...

8 years ago
Reply
RE: Trying to save a train

Look at - this looks very similar. To replace it, just use a suitable bridge rectifier instead of the PCB. /mike

8 years ago
Reply
RE: new car radios

Makes sense; most radios these days do the magic in software; the RF gets digitized and passed thru some form of a DSP to demodulate it (and convert t...

8 years ago
Forum
Reply
RE: Arduino in resting is at 255 when it should be 0

Do your lights turn on when you set the Arduino pin high or low? It sounds like whatever you are driving turns the lights on with a low on the Arduin...

8 years ago
Forum
Reply
RE: Breaker Question

The tandem probably has smaller terminals than a single breaker because they need to fit two in one space /mike

8 years ago
Reply
RE: PCB design - grounding tabs on SMD RJ45 jacks?

If you can, add vias to the mounting pads;; they will help hold the pad to the PCB. I did a project where I needed multiple RS485 lines to talk betwe...

9 years ago
Forum
Reply
RE: TR24 Circuit Board

That's fixable; you may need to use the resistor legs as jumpers to replace the damaged traces, and on one use a thin piece of insulated wire to conne...

9 years ago
Forum
Reply
RE: PCB design best practices & critique (RFC)

Can you post the .kicad_pcb file? /mike

9 years ago
Forum
Reply
RE: Is there a Power Pro that can say yeah or nay before I do this..

Most that I have seen have been 4-wire. They use 220 for the heaters and 120 (with a neutral) for pumps and lights. The OP specified that his syste...

9 years ago
Page 1 / 70
Share: