Notifications
Clear all
Development
7
Posts
3
Users
0
Reactions
4,931
Views
Feb 09, 2021 6:51 pm
I would grow the traces between the power input connector and the ground on the chip, and to the output connectors. They are quite thin now. You can also loop the trace from pin 10 to the V+ input over the top of the connectors to make this a single side design.
/mike
Feb 10, 2021 12:11 am
n1ist wrote:I would grow the traces between the power input connector and the ground on the chip, and to the output connectors. They are quite thin now. You can also loop the trace from pin 10 to the V+ input over the top of the connectors to make this a single side design./mike
Yes, certainly. This layout was just a sort of visual aid to demonstrate the connections and not intended to be the actual PCB. I've found that posting the schematic of a circuit often loses many people who are new and perhaps don't know how to read a schematic. So when I post a simple visual example like this, most every diy'er can read, understand and actually make the connections. Schematics can come later. :v:
Page 2 / 2
Prev
