Reed Switches
 
Notifications
Clear all

Reed Switches

7 Posts
6 Users
0 Reactions
5,070 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
[#54142]

Anyone use them? Caveats, gotchas, environment sensitivities?


6 Replies
DrNeutron
Posts: 2016
(@drneutron)
Noble Member
Joined: 14 years ago

Probably not the type you are asking, but I used to repair old (aka ancient) DTS 500 cash registers for a living about 30 years ago.
Back then, the keyboards used reed switches for each key on the keyboard and the key locks as well.
These were in very busy grocery stores and I maybe replaced a dozen that went bad (stuck) in those 15 years.
I must have soldered thousands of them to create new keyboards from old parts, this was the only way we could repair them as we bought old registers in bulk as spare parts.


Reply
Reddy_Kilowatt
Posts: 547
(@reddy-kilowatt)
Honorable Member
Joined: 19 years ago

I've had experience with them used on pneumatic cylinders. They were placed on both ends to tell the PLC where it was at. Pretty reliable as long as they are aligned correctly. and as mentioned above when they do finally stick they are done.

-Craig


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 19 years ago
P. Short wrote:Anyone use them? Caveats, gotchas, environment sensitivities?

I have used them, we'll discuss later. 🙂


Reply
Posts: 149
(@randomaker)
Estimable Member
Joined: 7 years ago

Im curious what youd be using them for. Some type of motorized prop?


Reply
Page 1 / 2
Share: