Renard based Servo ...
 
Notifications
Clear all

Renard based Servo controller

51 Posts
16 Users
0 Reactions
33.5 K Views
Posts: 393
(@soakes94)
Honorable Member
Joined: 18 years ago

Ive programmed my pic, put in a ren48lsd and cant get anywhere, when i connect my servo i get a small amount of movement but thats it, any ideas?


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

Did you update the first two bytes of the EEPROM memory space to be the start address (stored as HEX)

eg. Start Address 100 = 0x00 0x64
Start Address 256= 0x01 0x00


Reply
Posts: 2214
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago
soakes94 wrote:Ive programmed my pic, put in a ren48lsd and cant get anywhere, when i connect my servo i get a small amount of movement but thats it, any ideas?

Is this using the Renard Servo firmware?


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

Issue was resolved.. the start address wasn't programmed into the EEPROM.

This is using DMX based Servo control FW that I created. Seemed to be working, but all channels seem stuck on 4.58v now. (after turning on the "laser ??")

(Not my laser... just reporting what I was told)

I'm suspicious that the transistors may have been blown.


Reply
Posts: 393
(@soakes94)
Honorable Member
Joined: 18 years ago

My ren48lsd is now dead 🙁 All my pics are outputting 5V, doesnt matter if the channel is set at high or low, anyone got any ideas? Im going to start trying to reflash everything in the hope that doing that will fix it


Reply
Page 8 / 11
Share: