Renard based Servo ...
 
Notifications
Clear all

Renard based Servo controller

51 Posts
16 Users
0 Reactions
33.5 K Views
Posts: 393
(@soakes94)
Honorable Member
Joined: 18 years ago

Ive reprogrammed all the pics and nothing, I tried a working pic from another board and nothing, but that pic works in the other board, could it be my crystal? Is there a way to check? I dont have an oscilliscope, just a multimeter haha


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Follow the troubleshooting tips in the Ren48LSD wiki and see if anything hits there!


Reply
gdyrdave
Posts: 916
(@gdyrdave)
Noble Member
Joined: 16 years ago

Chris,

Is there a way to set limits in the firmware. I know the pulses are .5 to 2.5 ms but can we set the span to like .75 to 2.3 or something? my servos max out and I broke a gear in one already. I set the limit in Vixen but somehow when it goes to 0 it drives the servo to one end and chatters. I would be nice to hardcode this in firmware.
Thanks

Dave


Reply
Posts: 2215
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago

Currently there is no way to do that in the firmware.

If you set a cell to 0 then you've gone past any limit's you've set. In other words, if you sent a 0, the firmware pulses a .5. If you need a pulse higher than that you need to send a value higher than 0.


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago
ctmal wrote:Currently there is no way to do that in the firmware.

If you set a cell to 0 then you've gone past any limit's you've set. In other words, if you sent a 0, the firmware pulses a .5. If you need a pulse higher than that you need to send a value higher than 0.

If you were using 2.5, could you use dimming curves to accomplish the limits? Where 0 to 30 would result in .75 and maybe 90 to 100 is 2.3. Not the right numbers, but hopefully you get where I'm going.


Reply
Page 9 / 11
Share: