dirknerkle wrote:I don't know if it has that capability, but a workaround could be to use an SS8 controller WITH a start address and daisy-chain that into the servo controller. Out of a 16-channel stream, the SS8 would take the first 8 and pass the remaining 8 on to the servo controller. You'd probably want to use some lights anyway, so the 8 channels of the SS8 wouldn't be wasted, unless of course, you just chose to use it for the start address only and not use its 8 channels...
The firmware by default runs like the native Renards without a start Address.
Nice workaround though.
I put the firmware in the last 688 in a ren48lsd. Works like a champ. Now to make a servo interface card. Wish the addressing aspect of the firmware could handle this. used an ren8x8xb for testing before i put it in the 48lsd. Want to modify a 8x8xb just for servos. Thanks guys for the ideas.
Dave
LabRat wrote:Would a DMX 8 channel servo firmware for the 16F688 be of any use?
Did you ever write the DMX code? SInce I would like to program one of my ren48lsd chips with the code but I'm running my ren48lsd on DMX.
Steve
Yes, DMX in, and sends a series of pulses (1-2ms) based on the channel value (0x00 to 0xFF)
I've been trying to find time to write a DMX Address programming option into the FW, but it's not ready for primetime
just yet, so you would have to write the address into the EEPROM manually. This is trivial if you have a PICKIT, and
a little more hassle if you don't.
I'm optimistic that I will have two "robotic" lights running under my eaves this year.
Could you send me a copy of the code please? And I will give it a go when I have some spare time?
Thanks Steve
