hcl1 wrote:Well your could get ac switching solid state relays. and wire them into the gfci under the yellow tape that is ually cover a set of screws. Wire the hot from the on the control side. Depending on what relay you get alway open or always closed. You could have a light go off when ever there is no power to the circuit. You would have to run wire all the way to where you want to be able to see your new warning lights out. I might have a few of those relays. Ill have to look around.
exact same idea i was thinking except get a relay run the wires from the load side of the Gfi to the relay then the one set of power wires to feed the relay(to feed the warning light circuit )....the relay you want is a Normally closed so when the GFCI trips your warning light turns on 🙂 do this for how ever many gfci circuits you have (not you only need one feed circuit for any or all of the warning lights but still need to run load side of the gfci to the relay/relays) this sequence will tell you when and exactly which one will have tripped
A totally different approach for the same effect. Use GFCI's with indicator light, wire all of them to one panel inside. Then piggy back to a regular outlet at the outside location. I'm planning on a permanent sub panel in the basement at the front of the house, with a GFCI panel down stream, then to the outside outlets.
Skunberg wrote:A totally different approach for the same effect. Use GFCI's with indicator light, wire all of them to one panel inside. Then piggy back to a regular outlet at the outside location. I'm planning on a permanent sub panel in the basement at the front of the house, with a GFCI panel down stream, then to the outside outlets.
Haha genious,....just learn the indicator light status (either on when tripped, or on when there is power) but yeah this should work and would only take a few extra bucks as opposed to probably about 100 for the relay controlled indicator light idea.....good job !
Sorry boys, If using the "monitoring the load side" relay option, you would want to use the N/C normally closed set of contacts. When power is good, you want your indicator light/ buzzer to be off. If the GFI trips, the relay returns to its de-energized state (closes the contacts) and illuminates/activates your signaling device.
This is what we call a normally closed/ held open set up.
Its easier to see a single light turn on out of many VS seeing 1 go out (out of many that are on)
Plus, you are not illuminating all your indicators when things are good, just the ones when things aren't.
griffixdc wrote:Haha genious,....just learn the indicator light status (either on when tripped, or on when there is power) but yeah this should work and would only take a few extra bucks as opposed to probably about 100 for the relay controlled indicator light idea.....good job !
PLUS the reset is inside .... No Buurrrrrrrr.......
