Folks, I'm looking for feedback from DIYC members who used a Ren-W in their displays during the 2010 season. Specifically I'm looking for information that might make it a better device. If you had trouble with it this past year, please post what kind of trouble you had and what your solutions (if any) were. Nothing is off limits -- if you had trouble building them, finding parts, too confusing, needed better documentation, built them but didn't use them, or whatever.
This is a no-holds-barred thread so let it all hang out... within the confines of decency, of course... I want all comments, both good and bad. Thanks in advance!
-dave
we used the Ren-W for two displays this year. I htnk 5 boards in all with no troubles at all. all worked flawlessly.
Thanks Dirk!
I built four, tried to use two at computer (two different com ports) and two in the field to receive. Didn't work for me and went to one at computer and one in the field, this worked great (same as I used for Halloween). Didn't spend a lot of time to figure out problem. With both hooked up a lot and I mean a lot of missfires. I did change address's of x-bees. Also two x-bees were pro verision and two x-bees regular verision. I did search forums and found a couple of things to try (change channel, ground power supplys together etc) but to be honest never got around to trying them. Will set something up and try when weather warms up. But all that being said I loved the wireless and the one that I used for Halloween and Christmas worked GREAT! So I'm sure with a little troubleshooting on my part I can get both to work at the same time.
As above poster stated Thanks Dirk
RickeyS
Had all the parts in time for the 2010 season, didn't have the time to build 'em.
After the season:
Finished the SS8 - but for one last part - ARRRRRRG.
Finished the Ren-W.
I believe I have programmed the X-Bees (fingers crossed).
Mouser has my stuff in the mail - full test in February - need to pass a test at work to stay employed (late January).
So far, everything has been well documented and straight forward to build.
Had a couple hour hiccup with the X-Bees but I think I'm past that.
I will report further progress in February.
Greg
Update: X-Bees not playing nice. With me OR each other. Trying to re-establish ANY communication with either1
Hi:
One XBee Pro and one regular. Both are on REV 6 boards right now. Did not get time to use them in the display, but I did test them. The range was excellent. The Pro was inside a wooden building using a short router antenna. The RX was about 100 feet away in a plastic box with a ground plane for the short router antenna in the lid. The ground plane was made from aluminum tape. It ran flawlessly from what I could see.
Had to make a modification to the REV 6 board so it would interface to a 16 channel XMUS, but the SMA version ran with no mods.
