Greetings all...
I'm looking for some advice on what direction to go to create a new device or modify an existing one. What I'm trying to accomplish is a way to get notified when one of my GFCI's have tripped. I have 14 GFCI circuits that I fight with every year to keep from tripping. Usually if it dries out for a day after the rain, I am able to reset and all is well, but this year was particularly troubling. After resetting the circuits, the show would run for a while, and then one of them would trip again. By that time I was back inside the house believing that all was running perfectly.
So I would love to build some black box that would monitor the circuits and report status (or lack of status) back to me.
Anyone have something like this in place? Or have an idea on how to accomplish this? I'm pretty good with electronics and programming, so I think I can handle the development, once i'm pushed in the right direction...
Thoughts?
Thanks,
Jeremy
Well your could get ac switching solid state relays. and wire them into the gfci under the yellow tape that is ually cover a set of screws. Wire the hot from the on the control side. Depending on what relay you get alway open or always closed. You could have a light go off when ever there is no power to the circuit. You would have to run wire all the way to where you want to be able to see your new warning lights out. I might have a few of those relays. Ill have to look around.
Same idea but a little different.
Use an actual magnetic relay.
http://www.mouser.com/Electromechanical/Relays-I-O-Modules/Low-Signal-Relays-PCB/_/N-5g38?Keyword=120v+relay&FS=True
Place it in a small box and connect a cord to the 120v side that will connect to your display power you want to monitor.
Connect a small 2 conductor wire(spt1, or cat5) to the Normally Closed pins.
Run this wire back to your monitoring point where it will close the circuit and light an LED or sound a buzzer.
Crap
Now I want one.
Just one more thing to build.
Joel
Yep that will work great. I just hate the clicks. but since they aren't constant won't be bad. I should have those too sitting around also. Need to get rid of some of this stuff.
Correction...
You want to connect to the Normally open terminals, so when power is lost the circuit closes.
Would not let me edit last post.
Joel
You should only have clicks when power is lost or restored.
For me that would ideally only be two per season.
