Thanks. I wasn't sure if there were stand alone relays that worked in that direction. Usually we switch from the low side to turn on the high...
Thanks for the help!
Hi:
The answer is simple. Just use a 120 vac relay which is powered by the GFCI output. The relay is activated or closed when power is on. When the GFCI trips, the relay opens. You can use zip cord to run back to a central panel. The central panel has low voltage LEDs which are turned on or off, your choice, when the relay opens. Use a single pole, double throw relay. The relay just switches the power to the indicator in the control panel, that way you can run low voltage instead of 120 volts
jrock64 wrote:Same idea but a little different.
Use an actual magnetic relay.
Same idea but more DIY.
Just use an opto-coupler. You can even use a H11AA1, same one we use for zero cross detection and a couple 15K resistors.
Then parallel all of the output pins.
You should be able to place a pull-down resistor on the emitter to ground and a DC supply to ground and the collector. An LED or buzzer from ground to the emitter. Any input missing the AC should turn on the output.
ErnieHorning wrote:Same idea but more DIY.Just use an opto-coupler. You can even use a H11AA1, same one we use for zero cross detection and a couple 15K resistors.
Then parallel all of the output pins.
You should be able to place a pull-down resistor on the emitter to ground and a DC supply to ground and the collector. An LED or buzzer from ground to the emitter. Any input missing the AC should turn on the output.
I'm not sure that would work...with the outputs in series, any one input that is wired to AC would cause that one output to dominate all of the other outputs. I think that you need a wire-and connection, rather than wire-or connection. And driving an LED (as opposed to a buzzer) would not work, because the LED output would be on during the zero-crossing (albeit dimly).
P. Short wrote:I'm not sure that would work...
I'm sure that's not going to work.:roll:
I guess it would be a great 'something turned on' circuit.:-?

