Monitoring Power Fe...
 
Notifications
Clear all

Monitoring Power Feed Circuits...

29 Posts
11 Users
0 Reactions
10.8 K Views
n8huntsman
Posts: 562
(@n8huntsman)
Honorable Member
Joined: 16 years ago

What about a momentary normally closed relay wired with bell wire to your door bell transformer? Should be simple since it's all low voltage except for the power at the gfci.


Reply
griffixdc
Posts: 2512
(@griffixdc)
Famed Member
Joined: 16 years ago

@ n8huntsman ......would this setup be for all of the different circuits or one of these individually for each circuit or GFCI?

because it wont work if more than one GFCI trips


Reply
n8huntsman
Posts: 562
(@n8huntsman)
Honorable Member
Joined: 16 years ago

Good point. I guess you'ld have to have one for each gfci? I was looking for a relay as I described below but couldnt find a suitable one. I still think it could be done with a 555 timer in Monostable mode and a simple bosch style NC relay. But like you mentioned, youl'd need one for each GFCI. Could you conect them all to one relay with a diode inline or would that cause issues?


Reply
griffixdc
Posts: 2512
(@griffixdc)
Famed Member
Joined: 16 years ago
n8huntsman wrote:Good point. I guess you'ld have to have one for each gfci? I was looking for a relay as I described below but couldnt find a suitable one. I still think it could be done with a 555 timer in Monostable mode and a simple bosch style NC relay. But like you mentioned, youl'd need one for each GFCI. Could you conect them all to one relay with a diode inline or would that cause issues?

it wouldn't because if you have 2 or more gfci trips you double feeding the relay and if your using different breakers then your going to run 220vac to the relay if more than one trips. this will only work for one GFCi at a time 🙂

Allan Bradly sells a lot of stuff for control like this


Reply
n8huntsman
Posts: 562
(@n8huntsman)
Honorable Member
Joined: 16 years ago


Dang! Ok, it's getting kinda convoluted albeit, still doable. Sorry about my sloppy drawing. I dont wanna take the time to draw it in CAD knowing there is probably something wrong with it.
Note: I accidently switched the the 87 and 87A NO and NC pins, but you'll get the point. The fourth relay would be similar to this.

WP 000243

Reply
Page 4 / 6
Share: