wwwgator
@wwwgator
Eminent Member
Joined: Dec 24, 2007
Topics: 0 / Replies: 20
Reply
RE: Cutting SMD 5050-RGB LED Strip Lights

used an IP67 rated ribbon ( 1/2 round silicone sealed) cut into 27- 12" pieces for a 120"x80" star 81ch DMX just did rough assembly for testing. The...

15 years ago
Forum
Reply
RE: What Type of wiring?

If you broke off both tabs, make sure you jump the silver color terminals (Neut.) As for the colors of wire, ONLY white for the Neurtrals and ONLY gr...

15 years ago
Reply
15 years ago
Forum
DMX
Reply
15 years ago
Forum
Reply
RE: Power service

I concur with wirenut, you must have a neutral run for all sub panels/ 240VAC outlets. the ground is for FAULT CURRENT ONLY, "shall not be used as a N...

15 years ago
Reply
RE: dmx rgb controller from China, Any thoughts?

I used one in my Coro North Star- no issues One of the mods I made was de-soldering the 3pin XLR (DMX in/out) and replaced them with RJ45 jacks. I li...

15 years ago
Forum
DMX
Reply
RE: 2 x DMX Dimmers?

sometimes, you can plug in a door bell transformer to pull down the channel output to 0, we do that in a lot of instances when we have a high impedenc...

15 years ago
Forum
DMX
Reply
RE: RGB Sequencing questions - scripting - chasing over a solid color

here is a simple test sequence i built CH1-27- Coro North Star CH 28-44 LE (only used for a sign- too much ambition- not enough time) Ch45-26somthing...

15 years ago
Forum
Reply
RE: RS485 Hub??

PMCPA is correct, the boxes dont care what order they are in, as long as the start adddress are set correctly, and yes, you can overlap addresses. (ex...

15 years ago
Reply
RE: Temporary subpanel shopping list - need advice.

you are correct- 20A on L1 -18A on L2= 2A on Neutral

15 years ago
Reply
RE: 240v to two 120v circuits

Getting caught up on posts.....stumbled across this.... I am a Master Electrician and an inspector, so I thought I should chime in. Yes, you can cov...

15 years ago
Forum
Reply
RE: Finally Affortable Snowfall Tubes (FAST)

great work!! Video looks good!

16 years ago
Forum
Reply
RE: Finally Affortable Snowfall Tubes (FAST)

Hi, trying to follow along with the schem. All the LEDs in both drawngs are labled D? Although the color "wiring"diagram helps, still not sure what s...

16 years ago
Forum
Reply
RE: Monitoring Power Feed Circuits...

A buddy of mine used some old Koyo direct plc's we scrapped out of retired machines. they had 0-10VDC "anaolg cards". He took a bunch of amp-clamps h...

16 years ago
Forum
Reply
RE: Monitoring Power Feed Circuits...

Sorry boys, If using the "monitoring the load side" relay option, you would want to use the N/C normally closed set of contacts. When power is good, y...

16 years ago
Forum
Page 1 / 2