rayhjr wrote:Yes Sir. I use 33, or is it 30, anyway, on all my outputs.Sent from my SM-A505U using Tapatalk
They were 33 ohm. I ordered 25 back in July, .15 cents each, now .32 cents.
https://www.arrow.com/en/products/search?cat=&q=+4608X-102-330LF&r=true
Ok, I might try that. I get a lot of flickering on my tree when I first start a sequence, but it goes away fairly quickly.
MikeKrebs wrote:I am pretty sure that would take some work. If I have this correct, the differential receiver boards take in and output Pixel data without doing any interpretation of the data. The differential board would need a PIC or FPGA of some kind to read the pixel data, figure out its value and then trigger the SSR. The boards here kind of do that on the pixel side: https://www.pixel2things.com/
I'm assuming that this is about a widget that would take the same input as a WS2811 chip, use the first 8*n bits for the intensity of AC incandescent lights, incandescent light strings, or LED strings, and retransmit the rest of the data as if it were a WS2811 (or WS2811 clone). For a high channel-count board an FPGA would be the way to go. A single-channel device might be doable using the CLC, MSSP and timer modules of a PIC16F1704 (or maybe a PIC16F1503). Likely there would be low payback for a moderately difficult project.
Hopefully this is not an ignorant question.. but I was hoping someone could tell me.. Is the DC to DC convertor only used if power input is greater than 5v? I am looking to do a digikey order for a couple Items I missed and wanted to verify this before I do so. Thanks!!
Sent from my SM-A716U using Tapatalk
The DC to DC convertor is not needed if you are powering the board off 5v. You can just power the "controller" part of the PCB through J28 and switching the jumper on J18. This would isolate the pocketbeagle/serial/driver chips power from the pixel power.
jllracer55 wrote:Hopefully this is not an ignorant question.. but I was hoping someone could tell me.. Is the DC to DC convertor only used if power input is greater than 5v? I am looking to do a digikey order for a couple Items I missed and wanted to verify this before I do so. Thanks!!Sent from my SM-A716U using Tapatalk
Is there any ethernet options that are not USB? This project looks really good, so far I use RonP controllers, but am looking for something with some configurability, can this really drive 32 outputs? is there a theoretical limit of pixels with all channels driven?
