FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.7 K Views
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago
scooter_seh wrote:With the FPP 6 license stuff I cannot generate EEPROMs anymore, I upload a JSON file of the pinout that you can send to Chris to generate the EPPROM.

Uhh... What does the FPP6 license stuff have to do with generating an eeprom at all? You should still be able to generate an unsigned eeprom with your cape-info, default configs, string config, etc...


Reply
Posts: 87
Topic starter
(@scooter-seh)
Trusted Member
Joined: 12 years ago

Sorry maybe I didn't understand the license process correctly, I thought Chris had to generate a EEPROM with the "99" signature included in it.

dkulp wrote:Uhh... What does the FPP6 license stuff have to do with generating an eeprom at all? You should still be able to generate an unsigned eeprom with your cape-info, default configs, string config, etc...

Reply
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago
scooter_seh wrote:Sorry maybe I didn't understand the license process correctly, I thought Chris had to generate a EEPROM with the "99" signature included in it.

He needs to start with an actual eeprom.bin file for the board. That would then be signed as part of either process. For the DYI stuff, he would take the bin and sign it and send it back (I think). If the user preferred to purchase the license (generally faster, can be done in minutes), the eeprom would need to be already flashed on the board and then everything can be done from the cape-info pages in FPP and in the store. Either way, the eeprom.bin for the board is the important starting point.


Reply
Posts: 8
(@asualum2001)
Active Member
Joined: 5 years ago

I'm trying to use JLCPCB to create the BBB_16_Flex version of this board. I'm running into an issue though when I get to the product placement screen. All the components are in the right places, but their orientations are off. Someone made a similar comment a few pages back on this thread and it seems as though it is caused by changes to the JLCPCB website awhile ago. For the most part it's simple enough to orient them correctly as the resistors shouldn't matter and most of the others are labeled with a + sign. However, the chips are a little harder to figure out as I don't see any markers for pin 1 goes. For one of them, U2, I was able to figure it out by looking at the picture. The other one though, U3, isn't in the picture as it is covered up by the OLED screen. Does anyone know which way to rotate this part? Also, does it matter for the capacitors? I thought these are usually polarized, but I see nothing on the board nor the piece to rotate on the screen as to which side is supposed to be positive (see C3 as an example).

orientation

Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

What exactly are you trying to do?

I'm guessing that you are attempting to use the files that Scott placed on github to have jlcpcb fabricate the boards and and then have jlcpcb assemble those boards. Is this so, or are you trying to do something else? In any case, pin 4 of the 24LC256 is ground, so just examine the gerber files to determine which of the two corner pins (NW, SE) goes to ground, and that will be pin 4.


Reply
Page 116 / 126
Share: