FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.7 K Views
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Looking at the file BBB_16_Flex.CuTop.gbr from github, it appears that Pin 1 of U3 is on the lower-left of the component layout.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago
scooter_seh wrote:The EEPROM file is 4KB so any EEPROM 4KB or bigger should work. "24LC32A-I/P-ND" or "25LC640-I/P-ND" are two I found doing a quick search. I haven't tested them, so order at your own risk.

Thanks,
Scott

I'm a bit late to the thread, and unfamiliar with the design, but that advice looks a bit fishy. The first part is an i2c memory, the second is spi. Does the design really accommodate both types of parts?


Reply
Posts: 8
(@asualum2001)
Active Member
Joined: 5 years ago
P. Short wrote:Looking at the file BBB_16_Flex.CuTop.gbr from github, it appears that Pin 1 of U3 is on the lower-left of the component layout.

This is what I was looking for. Thanks for looking through the files to help me figure it out.


Reply
Posts: 87
Topic starter
(@scooter-seh)
Trusted Member
Joined: 12 years ago

Sorry about that, It needs to be I2C not SPI.

P. Short wrote:I'm a bit late to the thread, and unfamiliar with the design, but that advice looks a bit fishy. The first part is an i2c memory, the second is spi. Does the design really accommodate both types of parts?

Reply
joeytx
Posts: 249
(@joeytx)
Reputable Member
Joined: 19 years ago

Just completed the "Pi Zero 16 SMD" board. I had previously made the BBB16 , 24 pin 16 Port Expansion and the 4 port Receiver Out .

I wanted to see how the Pi Zero would work compared to the more expensive BBB version. The board is SMD and I ordered the bare board and hand soldered it. The board goes together rather quickly, the parts are fairly cheap, and works well.

The only issue I had was with FPP. On the BBB boards I was able to use FPP 5.5, and the EEPROM worked well without signing. I did purchase two licenses for it and a larger setup (one 24 and one 48), so I could upgrade to FPP 7.4 and use with X-Light Connect. On the Pi Zero I could not get the unsigned EEPROM to work right, every time I would make changes to the outputs, it would revert back to the defaults. I even made the changes directly to "co-pixelStrings.json" file, and rebooted. Then if I made a change it would revert back. This was on FPP 4.6, 5.3 and 5.5. I then tried 7.4 with the unsigned EEPROM and it worked perfectly (only limited by 50 pixels per output). I purchased a license for the Pi Zero (24 outputs), signed the EEPROM and it works perfectly.

Don't be afraid of signing the EEPROMs, they have made it very easy and straight forward. I know I could have asked for a voucher for the boards, but I really try to do my part with moving FPP and these projects forward.

Included are the 3D bases I did for the Pi Zero and the 24 pin 16 port expansion.

IMG 0823 sm
IMG 0825 sm
RaspPi Zero

Reply
Page 117 / 126
Share: