Dmx dc 8 ssr
 
Notifications
Clear all

Dmx dc 8 ssr

45 Posts
15 Users
0 Reactions
22.1 K Views
Posts: 789
Topic starter
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

OK. Working on redoing the ICSP header. I was unaware that I had it convoluted. I was thinking of using the LED for maybe a status, or heartbeat or something, but I might just 86 it. It wouldn't be too hard to change the DMX to a : A B A B instead of A A B B configuration.

Any other suggestions before I have new files to put up?


Reply
dpitts
Posts: 1020
(@dpitts)
Noble Member
Joined: 16 years ago

Now I am not at all familiar with the design since i do not have the software to view schematic. Nor do I have any knowledge of the hardware. I know most floods have RGB+white and this board would let your drive two floods. Is it possible to have 9 channels in case someone might want to drive three RBG strips? Just asking.


Reply
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago
dpitts wrote:Now I am not at all familiar with the design since i do not have the software to view schematic.

They are just images. You should be able to view them in your browser.


Reply
dpitts
Posts: 1020
(@dpitts)
Noble Member
Joined: 16 years ago

Your are right. I should have just clicked the link. Well it seems you are all out of pins on the processor.

David_AVD wrote:They are just images. You should be able to view them in your browser.

Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

The PIC program header (which should be on ALL boards) is in the wiki here:
http://www.doityourselfchristmas.com/wiki/index.php?title=PIC_Programming_Hints

I've verified the info there is correct. It is helpful to put a large friendly "1" or and arrow to pin 1 on the silk screen.


Reply
Posts: 789
Topic starter
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

Swapped DMX to an A B A B configuration, labeled a lot of parts, fixed the ICSP header (I think), and added an arrow to Pin 1 per Kirk's suggestion.
Should be able to view the pics like a normal thumbnail now.
Let me know if you see any other suggestions, I don't plan on ordering for a while.

Josh

PCB
Schematic

Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Oscillator?


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

16F688 can do DMX speeds without one.


Reply
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

The power cconnector would be better positioned at the text "DMX 8" The will give the short the high current path to the Fets gnds and the +V pins.
I always add the series diode on the Power input to the regulator, for those blonde senior moments.


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

Since you have DE/~RE tied to ground, there's no reason to tie DI to TX. If you had more pins available, I would tie DE and ~RE to an IO pin. On the other hand, I don't think you can use RC4 as a GPIO when you are using the UART.

/mike


Reply
Page 2 / 5
Share: