Warlock
@warlock
Noble Member
Joined: May 29, 2007
Topics: 133 / Replies: 814
Reply
RE: Helix Ether-Node Controller

Then you have a signal issue. Is your bridge responding ????

12 years ago
Reply
RE: Helix Ether-Node Controller

Plus your e1.31 bridge ahould have status leds to tell you if it is getting aignal

12 years ago
Reply
RE: Helix Ether-Node Controller

Make sure you have an xbee connection between the 2 units. If not then you jave an issue sending the commands between the mainboard and your ethernetn...

12 years ago
Reply
RE: Helix Ether-Node Controller

It should as you should be able to access the xbee no matter what but if it is affecting signal getting to the gear xbee will be affected

12 years ago
Reply
RE: Helix Ether-Node Controller

It might does said jumper config work with other gear for dmx ????

12 years ago
Reply
RE: Helix Ether-Node Controller

The heart beat led has to flash off and on at a steady rate while working to show it is recieving signal. If it is solid on there should be an error f...

12 years ago
Reply
RE: Helix Ether-Node Controller

The heartbeat led steady on means everything. If it is not flashing thn it is not rwcieving the dmx signal correctly. Then it has to be a programing i...

12 years ago
Reply
RE: Helix Ether-Node Controller

Best bet is to get ahold of Greg. Email him direct off his webpage

12 years ago
Reply
RE: Helix Ether-Node Controller

Odd considering others have had it. Maybe that is the issue

12 years ago
Reply
RE: Helix Ether-Node Controller

On your aScn controller details your board type is not selected like I pointed out in my other posts. It might be an issue not sure

12 years ago
Reply
RE: Helix Ether-Node Controller

On post #48 your config page for e682 number 2 doesn't show a board type selected.

12 years ago
Reply
RE: Helix Ether-Node Controller

Look at your name designation for your board. Its not selected for what controler you are using like your other config page is

12 years ago
Reply
RE: Helix Ether-Node Controller

2 things I noticed in you e682 no 1 config pic. 1 your last universe is not assigned ( universe 6 which has 150 channels) and 2 your config page has ...

12 years ago
Reply
RE: Cat 5 question

Ok cool thank-you

12 years ago
Reply
RE: Cat 5 question

I was going to use it for power only. These drip tubes only need power no data

12 years ago
Page 9 / 64