No error file generated on either SD card.
If it is not flashing thn it is not rwcieving the dmx signal correctly
Let me confirm my jumper settings with you guys.
HNC jumpers installed on H7,8,9 and on the upper 2 pins of H3 and 4
Ethernode jumpers installed on H5 and the right 2 pins of H3 and 4
Another point that may be of significance is that I had to make an adapter for the ST485 on the Ethernode. Mouser was out of the DIP version. I have the SMD version mounted to an adapter board and connected by jumper wires. Might that have an effect?
It might does said jumper config work with other gear for dmx ????
It might does said jumper config work with other gear for dmx ????
No idea as the E1.31 Bridge is the only piece of DMX gear I own. Even if there is an issue with the 485 side of the house wouldn't that leave the Xbee unaffected?
It should as you should be able to access the xbee no matter what but if it is affecting signal getting to the gear xbee will be affected
Make sure you have an xbee connection between the 2 units. If not then you jave an issue sending the commands between the mainboard and your ethernetnode
