Activity
 
Notifications
Clear all
todd1814
@todd1814
Estimable Member
Joined: Jan 28, 2016
Topics: 7 / Replies: 103
Reply
RE: 5v or 12v

I've been doing sequenced lighting for over 35 years and the most important thing I've learned is to keep it simple. The biggest frustration for me h...

5 years ago
Reply
RE: 5v or 12v

I still have both 5 and 12 and I'll just cut it short and tell you it's a bad idea. I have to think about it every time I do setup. What voltage is i...

5 years ago
Reply
RE: What gauge wire for power injection?

rsegreto wrote:Agreed, you should just be able to inject at the end. Rule of thumb with 12v is inject every 100 pixels. I've found the Spiker Lights...

5 years ago
Reply
RE: anyone used this transmitter (eBay)?

Randomaker wrote:Search for this on eBay- DSP PLL 87-108mhz Digital Wireless Microphone Stereo FM Transmitter Board Module Yes I know its super cheap....

5 years ago
Forum
Reply
RE: anyone used this transmitter (eBay)?

I've used the same transmitter for several years and plan to use it again this year. The listing says up to 20 meters (60 feet). Mine goes to a home...

5 years ago
Forum
Reply
RE: Falcon Player on PC?

I run my FPP master in a VSphere VM. That virtual server runs my media center, external facing applications, NAS, a virtual windows box and a few oth...

5 years ago
Reply
RE: No Data Halfway Through House Outline

I would also suggest checking your data. You may have the wrong number of pixels identified on the controller or test mode may not be sending data to...

5 years ago
Reply
RE: Use of a 400W 36V 11.11A DC Power Supply for 12v Pixels ?

The best way to make this work is decide what you want to power first. Then determine the number of volts and amps you need for each 'thing' you want...

5 years ago
Reply
RE: FPP PB16 Pixel Controller

scooter_seh wrote:The expansion boards only work with Kulp Controllers and my PB16 controllers. They do not work with the F16v3 or F16v2. While they...

5 years ago
Forum
Reply
RE: Idea for new lights?

I added wreaths to all my windows last year. Each one has 25 pixels arranged in 2 rings. They aren't perfectly aligned, which I like, and give me ad...

6 years ago
Reply
RE: DIY or Ready-To-Run

ClarkWGriswoldJr wrote:Ok guys need some help again. I decided not to buy the HC stuff. I just did a pixel presale order from Wally's Lights and bough...

6 years ago
Forum
Reply
RE: Buy or Make Own Cables

I don't worry about AC cables getting wet. I don't want them sitting in a pool of water but they otherwise sit on the ground. If I can keep connector...

6 years ago
Reply
RE: Power Injection - what to do with my setup

rayhjr wrote:As a rule of thumb 12 volt pixels is to PI every 100 Pixels so if you had power at the beginning and the end of 200 pixels all pixels wou...

6 years ago
Reply
RE: Warning message

Check “Enable Test Mode” on the test page.

6 years ago
Reply
RE: FPP Master/Remote Display Layout

Yes, your understanding is correct. I was confused about remotes until I set one up. It was much easier than I expected. Keep in mind you don't hav...

6 years ago
Page 1 / 8
Share: