Warning message
 
Notifications
Clear all

Warning message

17 Posts
5 Users
0 Reactions
7,110 Views
Posts: 15
Topic starter
(@blair)
Active Member
Joined: 6 years ago
9075B9B1 3888 43F9 A748 1421D2FD005D
7FD007C7 B861 4C9B 97C6 7999945649FE
13B425FE 78C2 40FC 9E99 057B313BE43C

ok I am not sure how to do this but I took off 1.31 and ticked enable BBB string cape put in on port 1 my string I am trying to test I have 49 use to be 50 I smoked one and put in my pixel count. And then went to status/control /display testing/enable test mode


Reply
Posts: 15
Topic starter
(@blair)
Active Member
Joined: 6 years ago
Screenshot (1)
Screenshot (2)
Screenshot (3)
Screenshot (4)

Reply
Posts: 110
(@todd1814)
Estimable Member
Joined: 11 years ago

Check “Enable Test Mode” on the test page.


Reply
Posts: 15
Topic starter
(@blair)
Active Member
Joined: 6 years ago

Yes I did still nothing could my new board be dead? It lights up but my oled on the kulp board does nothing also


Reply
Posts: 15
Topic starter
(@blair)
Active Member
Joined: 6 years ago

That’s a good question I don’t have anything to test them with it’s my first set of lights I didn’t want to order to much until I got comfortable with the systems and software. I will look to see if there is anything I can turn on to get the oled to work


Reply
Page 3 / 4
Share: