techs21
@techs21
Trusted Member
Joined: Dec 17, 2010
Topics: 14 / Replies: 50
Reply
RE: Sandevice E682 Power Problem

could the 5V DC‐DC Converter be bad and that is why it is blowing fuses soon as I give the controller power

8 years ago
Reply
RE: Sandevice E682 Power Problem

yes that is the same one in all the pics and in the manual

8 years ago
Reply
RE: Sandevice E682 Power Problem

I am not sure what else it could be or what else I should be looking for

8 years ago
Reply
RE: Sandevice E682 Power Problem

here is me testing to volts at J19 I have disconnected all other power and removed all fuses and the 2A fuse still pops

8 years ago
Reply
RE: Sandevice E682 Power Problem

yes the pin is jumped 2-3 for the 5v I soldered the missing pin and when I tried to power the controller it just pooped the fuse again

8 years ago
Reply
RE: Sandevice E682 Power Problem

are you talking about this pin there is solder on all 3 pins

8 years ago
Reply
RE: Sandevice E682 Power Problem

Ok here is the bottom of the board

8 years ago
Reply
RE: Sandevice E682 Power Problem

I have confirmed that as well. I was able to get it to power on all 3 yellow leds for about 10 mins then it popped the fuse and it is just popping the...

8 years ago
Topic
Replies: 69
Views: 13219
Topic
Forum
Replies: 24
Views: 10465
Topic
Forum
Replies: 1
Views: 1359
Topic
Forum
Replies: 2
Views: 1585
Reply
16 years ago
Forum
Topic
Forum
Replies: 3
Views: 3316
Page 4 / 5