Sandevice E682 Powe...
 
Notifications
Clear all

Sandevice E682 Power Problem

70 Posts
8 Users
0 Reactions
13.2 K Views
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago

If you are powering from 5V, the photo makes it appear as you are jumping pins 3-4 on the power selections, but it could be in shadow.

5V should have jumpers on 2-3. Please confirm.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
iflights wrote:If you are powering from 5V, the photo makes it appear as you are jumping pins 3-4 on the power selections as I don't see any jumper between pins 1&2, but it could be in shadow.

5V should have jumpers on 1&2 and 3&4. Please confirm.

5v power on j19 is pins 2-3 with jumper .


Reply
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago

Yes, as he said. Just a jumper on 2&3. Should have had that memorized by now.


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

yes the pin is jumped 2-3 for the 5v

I soldered the missing pin and when I tried to power the controller it just pooped the fuse again


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Are you certain that you are using a 5v power supply to power the board @ J19?
Is the polarity correct ? black to v- and red to v+ ?
You can eliminate 1/2 the board in troubleshooting by removing power from J18 .

You only need power on j19 for initialization and testing via clusters 3-1 to 3-4 and 4-1 to 4-4 .


Reply
Page 3 / 14
Share: