Sandevice E682 Powe...
 
Notifications
Clear all

Sandevice E682 Power Problem

70 Posts
8 Users
0 Reactions
13.2 K Views
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago
[#50318]

Hello everyone

I have finished soldering the E682 controller and when I power it on with 5v it blows the 2A fuse instantly. I have checked all the solder points and connections but no matter what I try it just blows the fuse.

Has anyone seen this problem or may know what the problem is. Thanks in advanced


69 Replies
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago

I would confirm proper orientation of the parts (many do not have a specific orientation, but just as many need to be put in properly), if you've eliminated solder issues as a source of the problem.


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

I have confirmed that as well. I was able to get it to power on all 3 yellow leds for about 10 mins then it popped the fuse and it is just popping them as soon as I power it up now, I get the bottom 2 yellow LEDs but that is it


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

can you take a good picture of top and bottom of board for us to look at


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

Ok here is the bottom of the board

E682
IMG 1733

Reply
Page 1 / 14
Share: