Activity
 
Notifications
Clear all
T.D.Sutton
T.D.Sutton
@t-d-sutton
Honorable Member
Joined: Oct 15, 2009
Topics: 71 / Replies: 374
Reply
RE: Pixel Matrix construction - PVC tube, Bullet Pixels - rear hole size ???

The plan is to use 1" OD PVC Conduit with the Pixels spaced 2" apart. I have just completed construction of 21 vertical strips of 75 Pixels each for...

9 years ago
Reply
RE: Power Injection Question

Ruppro wrote:If you are going to Power Inject between pixels 25-26 in the string, why not take it to 37-38, so you have the about same number of Pixel...

9 years ago
Reply
RE: Power Injection Question

ezellner wrote:The 0.5 volt voltage drop you are seeing is about right for 18 gage feed wire over a 4 meter distance. You should be able to run 50-5 v...

9 years ago
Reply
RE: Power Injection Question

mrGrumpy wrote:Would it help to think power injection at the 25 mark ahead of the 50 pixels. May need to size fuse better, but I think 5 is good. See...

9 years ago
Reply
RE: Power Injection Question

mrGrumpy wrote:Would it help to think power injection at the 25 mark ahead of the 50 pixels. May need to size fuse better, but I think 5 is good. See...

9 years ago
Reply
RE: Power Injection Question

Thanks Guy's that info is very helpfull and more or less what I had in mind. My Pixels are ex Aliexpress WS2811's, 5 v, and are only spaced about 3" ...

9 years ago
Reply
RE: Power Injection Question

Maybe a silly question ?? What size fuse do you use on each run from the power supply to your power injection ?? I will be using a 5 volt system.

9 years ago
Reply
RE: Making AC light sequencing easier in xLights

Thank you Keith, this should make life for us "Vixen" users a whole lot easier if/when we need/want to move our sequences into Xlights for Pixel anima...

9 years ago
Forum
Reply
RE: Any Model Railroad Enthusiasts?

I have a small fortune tied up in Marklin European HO, non DCC all Locos running under DC control after a minor mod to each one of them, been collecti...

9 years ago
Forum
Reply
RE: Powering ESP PixelStick Modules

That is all good info, I know the ubiquity gear, I installed a three unit set to shift the internet to two internet inaccessible sites out in the coun...

9 years ago
Reply
RE: Powering ESP PixelStick Modules

mrGrumpy wrote:Most WiFi routers will handle your plan...signal strength is the biggest issue. Home network routers may have too many wall to be peek...

9 years ago
Reply
RE: Powering ESP PixelStick Modules

gadgetsmith wrote:Here is a snapshot of the Pixel Device Setup screen on the ESPixelStick. As you can see, you specify the Starting Universe and Chan...

9 years ago
Reply
RE: Powering ESP PixelStick Modules

Brilliant information, and pics, that all makes things a whole lot easier to understand, thanks heaps 🙂 As always a picture is worth more than a t...

9 years ago
Reply
RE: Powering ESP PixelStick Modules

mrGrumpy wrote:Consider mounting your power supply and powering your pixels at the top. A much shorter distant to each string, and better control of ...

9 years ago
Page 6 / 30
Share: