Powering ESP PixelS...
 
Notifications
Clear all

Powering ESP PixelStick Modules

18 Posts
5 Users
0 Reactions
5,114 Views
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
gadgetsmith wrote:My first year (2015) I had lagging issues driving only 30 channels of data (10 RGB floods). I was using an old router I had lying around as "show router" (D-Link DIR-655), and my lone ESPixelStick was connected to that. Things were working normally at first, but after getting all my props up and running a full fledged show, that's when I started noticing the lag with the Floods. I ended up going back to a wired network. Last year (2016) I changed to a Ubiquity Router X (which I actually configured as two routers, so one is my home router, and the other is my show router). On the show router side I have two of the nanostation M2 access points for WiFi, one for the backyard, and one for the front yard. I chose the M2's as they are the ones Shelby decided to use for his setup, and he indicated they made a big improvement for him. In 2016, things worked great, not a lick of trouble, even with my 1800 channel mini-megatree. It's hard for me to say what the issues were since firmware was changed (v1.x in 2015, and v2.x is 2016), and also my router/access points changed. As mrGrumpy has indicated, he's been using some old routers lying around and getting a good signal and his stuff works great, others report the same too, so i'd say if you have stuff lying around, give it a try, nothing to lose, but if you do have trouble, i'd recommend trying the Ubiquity nanostation M2 access point.

Charlie

Actually, I didn't say my router's brand - it is also a Ubiquity EdgeRouter X, with a ubiquity PicoStation M2 AP. The another old router was turned into a second AP for expanded indoor access.

Before the EdgeRouter X, I did have an nice Cisco/Linksys running 9 universes, but it bricked it self to IP changes. Couldn't add or delete IP's. This unit worked fine, I didn't notice any delays.


Reply
Posts: 210
(@gadgetsmith)
Estimable Member
Joined: 13 years ago
mrGrumpy wrote:Actually, I didn't say my router's brand - it is also a Ubiquity EdgeRouter X, with a ubiquity PicoStation M2 AP.

lol. this is obviously the setup to go with then! 🙂


Reply
T.D.Sutton
Posts: 445
Topic starter
(@t-d-sutton)
Honorable Member
Joined: 17 years ago

That is all good info, I know the ubiquity gear, I installed a three unit set to shift the internet to two internet inaccessible sites out in the country for my Son in law a couple of years ago, brilliant stuff and relatively "cheap". As suggested I will try the gear that I have laying around first, but keep the Ubiquity gear in the back of my mind should I have hassles 🙂

Terry


Reply
Page 4 / 4
Share: