I had problems with 3 / 15 cards that I tested. ( including Samsung cards that I was able to verify as legitimate and Sandisk Endurance that was bou...
TomL8345 wrote:Is there a Testing function on firmware v4 similar to v3.x ? With firmware v3.x under the testing tab there was "disabled", "solid", "...
Also you shouldn’t hook up v+ from your cpu to the lights only ground and data ( since it’s being powered by USB ) generally you don’t want two power...
Check your pixel count Sent from my iPhone using Tapatalk
One of the trees is setup as a player instead of a remote. That will effect that tree..Sent from my iPhone using Tapatalk
They don’t have any channels assigned to them ( it Should be [1-270] and [271-xxx] ) I manually set channels when this happens. Then set xLights to ...
Did you upload the config to the k8 or enter it in? It’s on the controller tab in xLights. Can you do a test output from the K8-PB UI?I don’t believ...
Also you should upgrade to beta 4 as it has some timing benefits ( beta 4 shifts FPP remote to second input . Judging from your image your running bet...
You need to use something like FPP or xLights show scheduler to be your master ( I use a raspberry PI with FPP) For loading files on the pixel stick...
1) phantom pixels - do they clear up when playing a show or after boot? ( if not check for water, snow or ice in your connector. ) 2) for the incompl...
Close all other apps on your pc. I’ve found Cura tends to cause issues with pixel sticks so it might be that or another app. Maybe reboot your pc if...
Not sure if it’s a typo but .300 isn’t a valid IP address ( 255 is the max )Sent from my iPhone using Tapatalk
Are you trying to access them from your PC? You would need to connect to your show router on your PC. Sent from my iPhone using Tapatalk
