Activity
 
Notifications
Clear all
steve123
@steve123
Estimable Member
Joined: Nov 18, 2019
Topics: 5 / Replies: 181
Reply
RE: Seed pixel data out voltage

Yes. I think the same seed pixels they are likely tolerant of the higher voltage applied to the input. I looked at the datasheet for a GS8208 and it...

1 year ago
Reply
RE: Seed pixel data out voltage

When I load the pixel to my circuit which is an input to a 1G3157 analog mux and an TPD4E05U06 ESD protection device, the protection device clamps the...

1 year ago
Reply
RE: Seed pixel data out voltage

Yes, the 12V measurement is the unloaded output voltage of the DOUT of the seed pixel. A consequence is that connecting another string with a 5V max ...

1 year ago
Reply
RE: Seed pixel data out voltage

Indeed I am very surprised. I am wondering if this is unique to these particular pixels from Ray or if other vendors pixels also exhibit this behavio...

1 year ago
Reply
RE: Seed pixel data out voltage

The measurement of the DOUT signal with no load is about 8.6V. That appears to confirm my hypothesis the ESD device is clamping the data signal.

1 year ago
Reply
RE: Seed pixel data out voltage

MartinMueller2003 wrote: The spec for WS28xx pixels allows them to operate at up to 7V. That means the data line can go up that high as well. It also ...

1 year ago
Topic
Replies: 12
Views: 1814
Reply
RE: Multiple Matrixes with xLights

Another way to do this would be to create a custom model? That way, you could also define submodels for creating cool animations.

2 years ago
Forum
Reply
RE: ANOTHER pixel fire!

Santacarl wrote: With the resistor in line it probably wouldn't get hot enough to ignite. Exactly. The resistor limits the amount of power that can...

2 years ago
Reply
RE: ANOTHER pixel fire!

Utimgr wrote: I've never seen a MLCC catch fire, typically they fail open. That being said, they can burn open with too much voltage applied to them. ...

2 years ago
Reply
RE: ANOTHER pixel fire!

Santacarl wrote: It's a wonder there hasn't been a bad event somewhere along the way. There have been a few where the fire department has been calle...

2 years ago
Reply
RE: F.A.S.T. Finally Affordable Snowfall Tube - PCB Gerber Files?

I made these a few years ago and used Scott Hanson's BBB16 controller to drive them. You solder the pixel strip to the end and a xConnect pigtail to ...

2 years ago
Reply
RE: ANOTHER pixel fire!

I should also point out that for the 5V and the GS8208 pixels, there is a resistor in series with the capacitor. So, if the capacitor fails the resis...

2 years ago
Reply
RE: ANOTHER pixel fire!

Here is a 12V GS8208 pixel (taken from the web site). Looks like there is one capacitor near the top center of the board. I cannot make out the ther...

2 years ago
Page 2 / 13
Share: