Yep...they were 12VDC regulated. I've got my fingers crossed on the EVOs..... The jury is out on them as to operation and look so we'll see once the season gets under way.
I was extremely lucky twice. One pixel flamed but it was in a coro prop which luckily didn't combust and just scorched and melted a bit. The second one was on a pixel strip and that thin strip went up like kindling wood with a dose of lighter fluid poured on......Luckily I was outside and saw it before it could spread.....
How can you tell if the 'caps' are on the board edge?
Caps are generally a different colour than the resistors. The body of the cap is typically a light brown or beige colour whereas a resistor typically has a black body. Resistors typically have numbers and/or lettering on them whereas the caps don't. So, when you look at the board through the epoxy, look for the beige or brown looking components along the edge of the pcb.
Here are a few examples:
This is a tear down of a 12V regulated pixel. Note the two capacitors here are marked C1 and C2 along the edge of the pcb. The 78L05 is the linear regulator. The ws2811 is on the other side of the pcb.
Here is a 12V resistor pixel. There is one capacitor a bit further in from the edge (compared to the regulated pixel). There are three additional resistors on the other side of the pcb.
Here is a 5V pixel. There is one capacitor and it is positioned between the resistors which puts is closer to the center of the pcb.
Heat can also crack capacitors as well and process control is important when working close to ceramic capacitors. During pixel pcb assembly the pixel wires are typically soldered using large high power soldering irons. So, the capacitor on the 12V resistor pixel pcb is more at risk of damage compared to the 5V pixel for two reasons: first the capacitor is closer to the board edge and thus additional mechanical stress and second, it is thermally closer to the solder pad for the ground wire and thus additional thermal stress.
Thanks for the pictures......It's good to know what to look for.
Here is a 12V GS8208 pixel (taken from the web site). Looks like there is one capacitor near the top center of the board. I cannot make out the thermal paths clearly but electrically the capacitor is isolated from +V and the LED does not connect to ground so there should be no thermally conductive paths from the LED pads to the capacitor. So, these might be as safe as a 5V pixel. When the ones I ordered arrive I'll have a closer look.
I should also point out that for the 5V and the GS8208 pixels, there is a resistor in series with the capacitor. So, if the capacitor fails the resistor limits the current and you won't have a catastrophic failure.




