When I load the pixel to my circuit which is an input to a 1G3157 analog mux and an TPD4E05U06 ESD protection device, the protection device clamps the voltage to about 7.3V.
It apparently didn't destroy every pixel in that string past the first pixel. So at least those pixels (whatever they may be) aren't that sensitive to over
voltage on their inputs. It might be that the VDD on the chips in the pixels might be a bit high (which is determined in part by the VDD series resistor), which not only would explain why the digital outputs are high as well as why they're tolerating high digital input voltages. They might be fine driving similar seed pixels, but be a bit hard on other types of pixel strings.
Yes. I think the same seed pixels they are likely tolerant of the higher voltage applied to the input. I looked at the datasheet for a GS8208 and it specifies that the data input for that pixel type is 12V tolerant but the datasheet does not document the Vo specification. I would like to know which controller chip is used in the seeds I have and the seeds I plan to use and review a datasheet to confirm. I've asked Ray if he can send me this info.
The issue for me is that I am building a garage matrix. The matrix consists of an array of 24 panels in a 4 x 6 arrangement. Each panel is an arrangement of 36 x 9 seed pixels mounted to 4mm coro. I have designed a circuit and connector to interconnect the panels in a "plug and play" manner so there is no requirement to run wires between the panels. The purpose of the circuit is to daisy chain the data and power from panel to panel along a row and to loop back if it is the last panel in a row. Thus I have a requirement that the circuit interface with the data output of the pixel to perform this function automatically.
I am planning to use 3 wire 12V seeds for this but I don't know if they exhibit the same behaviour as the "4 wire data return" seeds I have on hand from Ray that I am using for testing.
