pakeonoahu
@pakeonoahu
Estimable Member
Joined: Jun 5, 2015
Last seen: Nov 18, 2026
Topics: 2 / Replies: 103
Reply
RE: How to implement 100 null pixels?

P. Short wrote:It's not too surprising that the WS2811 isn't too happy with 3V high pulses on it's input. It could go either way, but I wouldn't trus...

5 years ago
Reply
RE: How to implement 100 null pixels?

// THIS CODE IS FOR USE WITH THE 74HCT125 IC ONLY // THE 74HCT126 USES A DIFFERENT CODE void setup() { //********* PIXEL SETUP ********* int Output_...

5 years ago
Reply
RE: How to implement 100 null pixels?

P. Short wrote:Per the spec, the WS2811 chips require >3.5V on their inputs to guarantee that they adequately sense the '1' signal. So generally the ...

5 years ago
Reply
RE: How to implement 100 null pixels?

1pet2_9 wrote:I know. Don't you just drive an always-zero? Not for 2Y and 3Y out, that is to control how many pixels it splits, their OE are tied t...

5 years ago
Reply
RE: How to implement 100 null pixels?

packetbob wrote:Can you (or BarnabyBear) post a link to the code for the 74HC125 version? This is one of those thing that you may never need but can b...

5 years ago
Reply
RE: How to implement 100 null pixels?

74HC125 is active low for OE compare to 74126, and D9/D10 control needed to be active low as well. update: the circuit that I tested on, I don't need...

5 years ago
Reply
RE: How to implement 100 null pixels?

Just tested BB's code (modified by him to support 74HC125), worked perfectly, color matches and all sequences after from "X" pixels for out B and C ar...

5 years ago
Reply
RE: How to implement 100 null pixels?

P. Short wrote:So if the segment that went bad was 5 feet long (assuming 3" between pixels, so 4 pixels/foot) you would take a spare 5' cable, unplug ...

5 years ago
Reply
RE: How to implement 100 null pixels?

P. Short wrote:Aren't there pixel strings out there that have two parallel data paths so that if one goes bad, the other signals can still go down the...

5 years ago
Reply
RE: How to implement 100 null pixels?

I have been interested in the splitter for a while but not for splitting, I want to use it as an absorber, it always rain in my area from Nov to Dec, ...

5 years ago
Reply
RE: Holidaycoro Customer Service Is TERRIBLE!!

MartinMueller2003 wrote:Most of my controller to first pixel wires are Data and V-. No V+. I worry about the traces and connectors pushing that much c...

5 years ago
Reply
RE: Need Help With Pixels Not Lighting Correctly, ESPs, FPP

Do you have an extra TF card to test with older version of FPP? I started to test my setup with fpp 4.x that was loaded/upgraded early in the year. I...

5 years ago
Reply
RE: Getting shocked--by touching DC5V??

Some un-isolated devices/design tie the circuit ground to neutral, if your outlet is wired reversed (hot and neutral swapped) or you plugged in revers...

5 years ago
Reply
RE: HOT AIR Soldering Station Recommendations ?

Got this one for $34 , compact, once the hot air iron placed back to the holder, it automatically does the cool down(speed up fan turn off heat) befo...

6 years ago
Page 2 / 7