pakeonoahu
@pakeonoahu
Estimable Member
Joined: Jun 5, 2015
Last seen: Nov 18, 2026
Topics: 2 / Replies: 103
Reply
RE: Looking for small (1' tall?) antenna design

Look for examples on the 2 Meter HAM antennas, 2 Meter is around 144Mhz, FM radio band is around 2.7(3) meter wave length.

7 years ago
Forum
Reply
RE: Looking for small (1' tall?) antenna design

how about this? cut a wire with the length(ft)=234/Frequency, wind your coil, get a cheap VSWR bridge , connect your transmitter, antenna coil, and a ...

7 years ago
Forum
Reply
RE: New lights with no controller yet, can I power them?

samami wrote:Big Island In Honokaa. a bit far from me on Oahu.

7 years ago
Reply
Topic
Replies: 0
Views: 622
Reply
RE: NiuGuy Powersupply...opinions

Jameco.com got some good prices as well(below $35):

8 years ago
Reply
RE: Failed Mean Well power supply and questionable diagnostic techniques

DrewDennis wrote:Never. EVER. bridge a fuse! They are popping for a reason!! you can replace the fuse by wiring in an incandescent light bulb, if th...

8 years ago
Reply
RE: Buffer/line driver - null pixel without pixel

It has a voltage regulator and a line driver.

8 years ago
Reply
RE: Higher output power supply

pmiller wrote:I ended up ordering 4 of the ones I pictured earlier. I had to modify it with a 470 ohm resistor, 100uf capacitor and a NPN general purp...

9 years ago
Reply
RE: Higher output power supply

pmiller wrote:I also found this. 2 of them for the price of one. Btw, what are the break out boards they are selling on eBay for these power supplies?...

9 years ago
Reply
RE: Project to use a pixelstick type device as a FPP remote.

Barnabybear wrote:Hi, I’ve run the code on an ESP8266-01 (2M (FT25H16W)) with Dupont cables which sort of worked. The logic analyser showed the output...

9 years ago
Forum
Reply
RE: Project to use a pixelstick type device as a FPP remote.

Barnabybear wrote:Hi, great work. When you loaded up the ESP-01 was it in the ESPixelstick or stand a loan? I also used an ESP8266-12 to test this an...

9 years ago
Forum
Reply
RE: Project to use a pixelstick type device as a FPP remote.

Okay, found issue with ESP-01, I was using only ESP-12 for testing, I finally decided to load the code(the original) on an ESP-01 (4Mb), it didn't wor...

9 years ago
Forum
Reply
RE: Help with signal integrity

ags0000 wrote:How were they connected? Using the screw terminals on the pluggable connectors on the F16v3? Did you use both lines in each pair for the...

9 years ago
Forum
Reply
RE: Help with signal integrity

Ruppro wrote:Also, While other are able to go 50'-80' using Cat5, they are only sending one output's data over the Cat5 not 4 outputs I used three p...

9 years ago
Forum
Page 3 / 7