Last seen: Nov 17, 2026
I found the Japanese ENGINEER Solder Sucker with Silicone tube works pretty good, on amazon is around $25. Tip is replaceable soft silicone and heat r...
Maybe this can tie to your push button, then able to learn your rolling codes from your car.
1pet2_9 wrote:Building Christmas arches is not the purpose of PEX pipe, either. edit: to be honest, I think the 74HC04 is the better level shifter f...
P. Short wrote:That's not the purpose of those devices, although I'll believe you if you say that those exact parts work for you, not that you ever gi...
I was able to fix it, tried wings3d to import/export the .obj but the textures degraded greatly, using Blender I was able to import/export the .obj, x...
Just disable WAN port, your WIFI AP should be bridged with the LAN side, configure you LAN with the same subnet as your FPP Master and plug rpi into t...
hope you can get it fixed, but a bit hard to follow on FPP, your channels jumping around, where is starting channel 3691?
I believe Paul Zhang keep pixels at Amazon warehouse, contact him and you should get a replacement fast, I made purchases from him in the past, so as ...
I have the Si4713 module for my Pi also, it can put out max 120dBuv, not sure what the RF impendence is, no issue on open air to 30-40 feet, had issue...
Is there a reason using Qn8027 vs SI4713 ? I have the SI4713 that already has support under FPP for rpi, able to pull the mp3 title for RDS or add y...
The ESP8266 ADC is useless for me, it only accept 0-1v and noisy, using voltage divider knocking down to that level and not enough scaling. I use ADS...
I ran 45ft 12AWG power cable pairs from my power supply to my first pixel, there's no way by running a single data wire to my first pixel would work, ...
I would be worry about the 30A screw terminal that's rated for 30A like Dan said, eight ports @3.75A each will pull 30A, with 7.5A x 8 = 60A on that t...
I did one using Shelby's e131 library example awhile back on an ESP-12, the library was dated 2015 and I know it has many updates and not sure still w...
