Can this string be ...
 
Notifications
Clear all

Can this string be repaired?

15 Posts
8 Users
0 Reactions
2,621 Views
Posts: 62
 DILA
Topic starter
(@dila)
Trusted Member
Joined: 19 years ago
[#56043]

I am new to pixels, so not sure how to proceed. I have tested about 20 Paul Zhang 12v ws2811 100ct resistor strings and this is the first one with a problem. The first 20 pixels respond correctly, then it repeats red, green, blue, white, dead for the last 80. I turned off test mode in FPP and the first 20 went off, rest stayed on with the same pattern, almost I did get some purple. Powered down Kulp16 and when back on now only first 20 pixels respond. Tried another string on same port and port is fine. Any ideas on whats wrong? If its just a bad pixel I'll cut it out instead of the hassle of getting one string replaced.

thanks

Bob


14 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

You have nothing to lose by cutting out pixel #21 and reconnecting pixel # 22 to pixel # 20.
I would make the connections here temporary just to confirm #21 is the culprit.
It could be pixel # 20 is not passing the data to pixel # 21

Some folks just chop out the last working pixel and the first not working pixel as a quick solve ,but I like to save the last good pixel if it is not the issue .


Reply
Posts: 105
(@pakeonoahu)
Estimable Member
Joined: 11 years ago

I believe Paul Zhang keep pixels at Amazon warehouse, contact him and you should get a replacement fast, I made purchases from him in the past, so as my cousin did this year, Paul will make it right especially you have a bad string.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Normally I cut out the last working and first non working pixel. You dont know if the issue is that the last working pixel is sending garbage or that the first non working pixel is actually broken.


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, to be most efficient and keep joints to a minimum. If 20 works and 21 doesn’t, cut the string between 20 and 21, then attach 21 to your data. If 21 works then 20 is at fault and can be removed, if 21 doesn’t work then it can be removed.


Reply
Page 1 / 3
Share: