How to implement 10...
 
Notifications
Clear all

How to implement 100 null pixels?

68 Posts
11 Users
0 Reactions
10.8 K Views
Posts: 105
(@pakeonoahu)
Estimable Member
Joined: 11 years ago

Just tested BB's code (modified by him to support 74HC125), worked perfectly, color matches and all sequences after from "X" pixels for out B and C are passing to the string.


Reply
Posts: 1420
Topic starter
(@1pet2-9)
Noble Member
Joined: 6 years ago

How did you test it? With some arduino-only setup?


Reply
Posts: 119
(@packetbob)
Estimable Member
Joined: 17 years ago
pakeonoahu wrote:Just tested BB's code (modified by him to support 74HC125), worked perfectly, color matches and all sequences after from "X" pixels for out B and C are passing to the string.

Can you (or BarnabyBear) post a link to the code for the 74HC125 version?
This is one of those thing that you may never need but can be a life saver when you need it....
Possibly not for Xmas displays but for other types of pixel light display installations...
Especially when one party does the pixel and wiring install and another supplies the controller and the requirement that the pixels be in a single string doesn't get spelled out....
And the pixel wiring is not really accessible to fix...


Reply
Posts: 1420
Topic starter
(@1pet2-9)
Noble Member
Joined: 6 years ago

Wouldn't you just tie the 74HC125's OE to always-on?


Reply
Posts: 105
(@pakeonoahu)
Estimable Member
Joined: 11 years ago
2022 01 11 11 06 20

74HC125 is active low for OE compare to 74126, and D9/D10 control needed to be active low as well.

update: the circuit that I tested on, I don't need port A, just need to add 150ohm resistor to 4Y out if you need it.

Schematic Splitter 2022 01 10b

Reply
Page 11 / 14
Share: